Coursecode: wbp521
Coursename: Length measurement technique

DUT creditpoints: 0,5
ECTS creditpoints: 1

Faculty of Mechanical Engineering and Marine Technology

Lecturer(s): Rongen, F.J.I.M., Spronck, ir. J.W. (coordinator)

Tel.: 015-2786852

Catalog data:
See description

Courseyear: 3
Semester: x/x/x/x
Hours p/w: -
Other hours: -
Assessment: See remarks
Assessm.period(s): See remarks
(see academic calendar)

Prerequisites: -

Follow up: -

Detailed description of topics:

  • Inspection measurements of products

  • Choice of measuring instruments in relation to fabrication tolerance

  • Angle measurements

  • Measurements of a Broots with a projection-measurement microscope

  • Angle measurements of a cone

  • Calibration of a dial indicator

  • Determination of measurement inaccuracy

  • Measurements of axes

  • Stating the right measuring means with serial production of axes

  • Surface texture measurements

  • Straightness measurements with an autocollimator

  • Alignment with a pointing telescope

  • Length measurement technique applied with scientific research

Course material:

manual

References from literature:

Remarks (specific information about assesment, entry requirements, etc.):

The practical work exists of four dayparts (in one week) during the first and second dimester; if neccesary the third and fourth dimester. Assessment: completing the work with a result satisfactory to the management.

Goals:

Provide of knowledge in the technology and importance of accurate measurement.

Computer use:

Laboratory project(s):

See description

Design content:

Percentage of design: -