Coursecode:
mt082p
Coursename: Midship section
exercise
DUT
creditpoints: 1,5
ECTS creditpoints: 3 |
Faculty of Mechanical
Engineering and Marine Technology |
Lecturer(s): Vink, ir. J.H., Drooger, J.C. |
Tel.: 015-27 82700/85923 |
Catalog data:
Midship section, classification rules, scantlings |
Courseyear: 2
Semester: 0/0/x/x
Hours p/w: -
Other hours: 80 hours
Assessment: See remarks
Assessm.period(s): -
(see academic calendar) |
Prerequisites: mt800, mt083p1 |
Follow up: mt827 |
Detailed description of topics: Determination
of the scantlings and making the midship section plan of a vessel, using classification
rules. Various computer programs can be used, such as:
- midship section scantlings according Lloyd's Register Rules;
- various programs for calculation of cross sectional properties such as section modulus
and moment of inertia; determination of optimal I-beam dimensions for a required section
modulus.
Determination of the still water bending moment (SWBM)
Calculation of stresses in elements of the structure.
Answering some questions about a work drawing.
Summarizing the answers and calculations in a report. |
Course material:
- Lecture notes: mt082P: Manual structural exercise. Available at Sales department WbMT.
- Lecture notes: mt810P1: Notes on the construction of ships and their elements, parts I
and II, Shipbuilding profiles. Available at Sales Department WbMT.
- Title: Shipbuilding profiles. At small drawing room MT.
|
References from literature: |
Remarks (specific information
about assesment, entry requirements, etc.):
- Examination: The credits obtained will be based upon the drawing of the midship section
and the report. The exercise is considered sufficient when the credits obtained are 6 or
higher, the exercise is returned to the student and the student has discussed the result
with the university staff responsible.
- Admission: The exercise is open to students that have succesfully followed the course
mt800 (Ship Construction MT) and have attended mt083P1 (Introduction exercises CAD).
- At start of the fourth quintal an instruction will be given for which registration is
possible via the bill board.
- The date of the instruction will be published at the billboards. The exercise must be
submitted within six weeks after receipt of the exercise description. If not returned in
time, a new (different) exercise will be given to the student.
- Location: Calculations: small drawing room MT (above towing tank). Drawing
(hand): small drawing room oMT (above towing tank), or drawing (CAD): SUN-room
201/202, block II, 2nd floor, (according schedule/appointment).
|
Goals:
See mt827 |
Computer use:
PC-programmes and CAD at SUN-stations |
Laboratory project(s): |
Design content: |
Percentage of design: 75% |